Navigation Light Panels

EXCLUSIVE "EMERGENCY REPAIR PLUG"

If anything on the plug-in-printed circuit board should fail, the board may be removed for service and replaced with the "Emergency Repair Plug". This allows for normal operation of all lights. A status lamp indicates when the "Emergency Repair Plug" is in use.

Standard Features:

Visual and audible alarm of lamp failure or blown fuse
Solid State current sensors for total short circuit protection
Plug-in printed circuit board
Any wattage lamp in any circuit
Available in flush or surface mount
System Test Button
Emergency repair plug standard
Each panel labeled to owner's specifications
Lifetime Warranty of Plug-in PC Board

Complies With:

IEEE Standard 45 Section 34.2
ABS Section 35.109
USCG Section 111.75-17

Model Shown Above: NLFM5D5SUG120A

NL - Navigation Light Control Panel

FM - Flush Mounting
SM - Surface Mounting

5D - Number of Dual Lamp Circuits
5S - Number of Single Lamp Circuits

UG - Ungrounded Neutral means both sides of
each branch circuit are switched and fused

GN - Grounded Neutral means only the hot side of
each branch circuit is switched and fused

120A (120 VAC input power)
220A (220 VAC input power)
12DC (12 VDC input power)
24DC (24 VDC input power)
32DC (32 VDC input power).

Options Available: (select lights needed)

DP - Dual Power Sources
RA - Remote Alarm
MO - Man Overboard
FL - Flashing Light
WL - Whistle Light
F/A - FWD/AFT Motion Selector
AU - Automatic on and off
AD - Alarm Lamp Dimmer
RS - Rotary Switch for Task Lights
OL - Obstruction lights
LD - Running Light Dimmer Cont. (Military Only)

When ordering, be sure to provide a list of the light names.

Dimensions
Surface Mount	12" H x 14" W x 4" D 10" H x 12" W x 4" D	Note: The Dimensions shown may very or be rotated 90 degrees depending on the number of circuits.
Flush Mount	18.5" H x 14.5" W x 4" D 14.5" H x 12.5" W x 4" D	Hole 16" x 12" Hole 12" x 10"